Jiangyin Hengyi Engineering Machinery Co., Ltd

High quality is our obligation,great service is our mission!

Home > Exhibition > Content
JCB HAMMER moil point chisel to install and use to pay attention to what
- Oct 08, 2017 -


JCB HAMMER  moil point chisel should be careful to check the installation of the breaker before the piston is not smooth, and then we actually have to look at it itself is not there any flaws, Moreover, we actually It is necessary to pay attention to look at its guide sleeve wear is not too large, when it is a problem, on the maintenance and replacement after the installation.

Then, on the broken JCB HAMMER  moil point chisel in the use of time, it should be noted that the vertical contact with broken objects, for example, in terms of the object tilt, then, to a large extent, the drill rod actually It is necessary to pay attention to the object should be perpendicular to the contact, and finally broken.

 

2.SOCOMEC SANDVIK JCB HAMMER ROTAIR CP-RX 尖头钎杆.jpg


When the JCB HAMMER  moil point chisel into the stone or concrete into the time, we actually have to pay attention to see the stones or concrete is not the phenomenon of fracture, if there is no broken case, then To a certain extent, it is necessary to pay attention to be moved to a certain distance and then hit, until the break can be pulled down, can not be hard pull, to avoid the phenomenon of broken drill rod.

Then, on the JCB HAMMER  moil point chisel in the use of the time, can not be used as a lever to use the lever, do some pry stones or do not crack the work, in terms of this aspect, in fact, It is easier to cause the phenomenon of broken drill rod. On the drill rod can not be hit in a long time, a long time hit a little bit, on its degree to a certain extent, it will be easier to cause the tip of the drill tip is too high.

Finally, when using the JCB HAMMER  moil point chisel, the drill rod is too small or too thin for the contact object or the contact object, and the crusher can not be hit. In the formation of the air when the piston and drill rod force is too large, that is, will be more likely to cause JCB HAMMER  moil point chisel and flat pin damage.

 



Jiangyin Hengyi Engineering Machinery Co., Ltd

Add:No 19 Dongsheng Road,Chengdong Street,Jiangyin,Jiangsu province,China

Mob: 86-15161619377 
Tel: 86-510-86392508
Fax: 86-510-86392508
Email: Kristen-li@hotmail.com
Website: http://www.hengyichisel.com